Help articles › Building Help
Building Help
Fixes for the problems that come up mid-build.
17 articles
- How do I achieve the best finish using your horizontal attachment setup?
- Why didn't my Master Series Rivet Flaring Press come with the base plate pin?
- Do you offer a drill and tap chart?
- I want to make my own handles and backspine, what do I need to know?
- How do I drill my own handle materials for these kits?
- My Typhoon handles had small spots on them when I unwrapped them from the oiled paper. What are they?
- My screws are protruding to the inside of the folding knife liners. What do I do?
- How do I align the blade in the center of the folder when installing it?
- I want to make my own folder kit handles and backspine. What do I need to know?
- What do I need to know about heat coloring my bolsters?
- My Typhoon handle is too hard to close and lock, or when in the closed position, the blade edge is close to the edge of the pocket. How do I fix this?
- My Screws are protruding to the inside of the knife. What do I do?
- On my kit, my bolster does not sit flush. How do I fix this?
- I've adjusted my blade to the center of the liner, but need to adjust the lock engagement, how?
- I want to remove the pre-installed thumbstuds. How?
- On my folder kit, the bolster does not sit flush. How do I fix this?
- My handles are bowed when I insert my Typhoon inlays. How do I fix this?
Can't find what you need?
Contact us